Size Guide

Follow the instructions below to determine your wrist size. The general rule for finding your bracelet size is to add 2cm (0.8in) to your wrist size measurement. To ensure the most accurate bracelet size, always use the size chart for your selected bracelet type. If you prefer a looser fit, you may wish to size up.

You'll need:

• Flexible measuring tape or ruler
• String or strip of paper
• Pen or marker

OPTION 1: USE A FLEXIBLE MEASURING TAPE

With your palm open and facing up, wrap the measuring tape around your wrist, just above your wrist bone. Note down measurement of your wrist size.

OPTION 2: USE A STRING

With your palm open and facing up, wrap the string or strip of paper around your wrist, just above your wrist bone. Mark where the ends meet with a pen or a marker. Next, lay the string or piece of paper flat and measure it to where you've made the mark to find your wrist size and note it down.

Using the wrist measurement you've just found, find the chart for your preferred bracelet type to see which bracelet size corresponds with your wrist size.

How to Measure Your Circumference

Circumference is the measurement around the base of the finger

You’ll need:

• 5mm wide strip of paper
• Pencil or fine tip pen
• Ruler

STEP 1:

Cut a long strip of paper that is 5.0 mm wide.

STEP 2:

Wrap the strip of paper around the base of the desired finger. For the most accurate result, pull the paper as tightly as possible.

*Don’t worry! The correct ring size is determined on the basis of a tight measurement; the ring itself won’t fit that tightly.

STEP 3:

Ensure that the paper is evenly overlapped and pulled tight, and mark where the strip of paper meets itself.

STEP 4:

Measure the length of the strip of paper in millimeters. Round off to the closest whole millimeter.